|
||
| Product Testing & Calibration Unit |
| About
Us | Rubber Products | Bearings
| Seals | Condoms | Exam
Gloves | Surgical Gloves
| Household & Industrial Gloves | Tyre Testing | Calibration Services/Sales | Others | Contact |
||||
Product Testing & Calibration UnitSemi-Automatic Pinhole Water Leakage Condom Tester  High demand for the use of condoms, either within or outside the country, has increased the QA testing activities of the said latex product. Any condom which has pinhole(s) present is obviously not acceptable. The PTL has come out a new design of equipment for pinhole testing of condoms and the tester is according to ISO 4074:2002. The principle of water leak test is by filling the condom with a specified volume of water (300ml) and examining for visible water leakage through the wall of the suspended condom. A new Water Leakage Condom Tester was developed with the capacity to test 10 units of condom at the same time. The equipment was designed with self-timing adjustable water filling and a fixed volume of water, 300ml, for each condom is used. It has a simple condom holding system. The technique for measuring 300ml of water and filling water into the condom is very fast, simple and accurate. The equipment is built complete with water recycle system to prevent waste of water, and thus saving cost. Back |
||||
|
The Government and Malaysian Rubber Board shall not be liable for any loss or damage caused by the usage of any information obtained from this site. Malaysian Rubber Board 2002. All Rights Reserved. Best viewed with Internet Explorer 6.x browser.
|
||||