Abstract - Short Communication Estimation of Coating Thickness of Polymer Coated NR Gloves


	Journals and Publications


	Publications of MRB Latest Publications MRB Digest Journal of Rubber Research 3^rd Qtr 2008 Vol 11(3) 2^nd Qtr 2008 Vol 11(2) 1^st Qtr 2008 Vol 11(1) 4^th Qtr 2007 Vol 10(4) 3^rd Qtr 2007 Vol 10(3) 2^nd Qtr 2007 Vol 10(2) 1^st Qtr 2007 Vol 10(1) 1^st Qtr 2006 Vol 9(1) 2^nd Qtr 2006 Vol 9(2) 3^rd Qtr 2006 Vol 9(3) 4^th Qtr 2006 Vol 9(4) Submit paper/article Order Form	Abstract Short Communication Estimation of Coating Thickness of Polymer Coated NR Gloves A.H. Eng The coating thickness of polymer coated NR gloves was estimated by using a stylus surface profile machine. During the measurement, the gloves were stretched to a suitable length, and the polymer layer which was harder than NR, cracked, exposing the NR to the surface. When the stylus was driven across the surface, the sharp pointed end of the stylus dropped into, and came out from the cracks, generating a series of peaks that corresponded to the coating thickness of the polymer layer. The coating thickness of the polymer-coated gloves in cuff palm, and finger regions was measured and compared. The significance of the results is discussed in relation to the way these gloves were made. back
The Government and Malaysian Rubber Board shall not be liable for any loss or damage caused by the usage of any information obtained from this site. Malaysian Rubber Board 2002. All Rights Reserved. Best viewed with Internet Explorer 6.x browser.